Electrical · Streatham SW16

ABS Sensor Replacement for Streatham Drivers, 20 Minutes Away

We're about 20 minutes from Streatham, via Mitcham Lane and through Mitcham to Hackbridge. We read the ABS fault codes and test the circuit to find the real cause before quoting, and ABS sensor replacement starts from £89.

Get an instant price Call 020 4629 9469

★★★★★ 4.9/5 from 87 Google reviews
~20 min from Streatham
Mon–Sat 8am–8pm

Audi SQ5 in for brake and wheel-speed work at KITH Cars Garage & Bodyworks, Hackbridge

ABS Sensor Replacement for Streatham drivers

Stop-start on Streatham Hill and disturbed ABS sensors

Streatham Hill and Streatham High Road are slow, bus-heavy red routes with a 20mph limit and frequent crossings. Driving there means constant braking, and cars that do a lot of it need pads and discs more often. Every time brakes are changed, the ABS sensor and its wiring sit right next to the job, and a sensor that has corroded in place can crack when it's disturbed. That's why so many ABS lights appear shortly after a brake job, even when the work was done properly.

Around Streatham Park and the Victorian terraces off the high road, cars are parked tightly on narrow streets. Squeezing in and out means kerb knocks, which can damage a sensor or its wiring. Roads around Streatham Common and The Rookery are quieter, but plenty of those cars do short trips and sit for long periods, which suits corrosion. The Streatham Wells traffic trial caused heavy queues on the A23 before it was suspended, and those months of extra stop-start traffic only added to brake wear.

We read the ABS module to find the wheel and fault type, compare live wheel speeds and test the sensor circuit. If the fault started after brake work, we check the connector and wiring routing first, because a simple fix is sometimes all that's needed. Otherwise, we'll quote for an OE or OE-equivalent sensor, or a reluctor ring or bearing if that's where the fault lies. Everything is explained in a written quote, so you know what you're paying for.

The route is Mitcham Lane and Streatham Road to Figges Marsh, then London Road through Mitcham to the Cricket Green, Cranmer Road and Carshalton Road into Hackbridge, about 5.5 miles. With only the ABS light on, the car is usually safe to drive carefully, or we can arrange collection. Our 3-month workmanship warranty covers the repair.

Electrical

ABS Sensor Replacement: what’s involved

Each wheel has a speed sensor that reads a toothed or magnetic ring turning with the hub or driveshaft. The ABS module constantly compares the four signals. If one wheel slows too quickly under braking, the system releases and reapplies that brake to stop it locking. The same signals feed traction control, stability control and often the speedometer, hill-hold and tyre pressure warning.

Older cars use passive sensors that generate their own signal. Most modern cars use active sensors, which are powered by the ABS module and often read a magnetic encoder built into the wheel bearing seal. Sensors sit right next to the brakes, exposed to heat, water, salt and brake dust, so corrosion, damaged wiring and failed connectors are common. When a signal drops out, the system switches ABS and stability control off and lights the warning. Your normal brakes still work.

From £89Written quote first

45 minutes–2 hoursTypical time in the workshop

3 monthsWorkmanship warranty

4.9★87 Google reviews

Signs of an ABS sensor fault

ABS warning light on

A steady ABS light means the system has switched itself off. Normal braking still works, but the wheels can lock under heavy braking.

Traction and stability lights too

Because they rely on the same wheel speed signals, the traction control or ESP light usually comes on with the ABS light.

Light comes and goes

An intermittent warning, often after bumps, in wet weather or at a certain speed, usually points to damaged wiring, a loose connector or a corroded sensor.

ABS pulsing at low speed

If the pedal pulses and the ABS activates when stopping gently, a sensor may be giving a false reading from a dirty sensor or a cracked reluctor ring.

Speedometer or tyre warning faults

On cars that take road speed or tyre pressure monitoring from the wheel sensors, a faulty sensor can upset the speedometer or set a tyre warning.

Other systems disabled

Hill-hold, cruise control, stop-start and some electric parking brake functions may stop working when a wheel speed signal is missing.

When should it be done?

ABS sensors have no replacement interval. They are replaced when they fail or when their wiring is damaged. Get the car checked as soon as the ABS light comes on, because the car won't stop as well in an emergency on a wet road without ABS and stability control. An ABS warning light that stays on is also an MOT failure. Faults often show up after brake, hub or suspension work, when a sensor or its wiring may have been disturbed.

ABS, traction or stability warning light on
Intermittent warnings in wet weather or over bumps
Warning lights after brake, wheel bearing or suspension work
Before an MOT if the ABS light is showing

How we replace an ABS sensor

Check-in and symptomsWe ask when the light appears and whether any work has been done recently, as disturbed wiring after brake or suspension work is common.
Diagnostic scanWe read the ABS module fault codes to identify which wheel is affected and whether the fault is signal, circuit or plausibility related.
Live data and testingWe compare live wheel speed readings on a road test or ramp and test the sensor circuit with a multimeter or oscilloscope to separate sensor, wiring and ring faults.
Inspect the ring and bearingWe check the reluctor ring or magnetic encoder for cracks, corrosion or damage and check the wheel bearing for play, as either can cause a false signal.
Written quoteWe explain the cause and give you a written quote. If the encoder is built into the wheel bearing, we'll explain why the bearing may need replacing.
Replace the sensorWe carefully remove the old sensor, which is often seized in the hub, clean the mounting, and fit the new sensor with its wiring routed and secured correctly.
Clear codes and road testWe clear the fault codes, road test to confirm all four wheel speeds read correctly and the warning lights stay off, and run any calibration the car needs.

Parts we fit

Sensors must match the car exactly. Active and passive types are not interchangeable, and connectors and lengths vary between models and even between axles. We fit OE or OE-equivalent sensors from manufacturers such as Bosch, ATE or Continental. Where the wiring is damaged we repair it properly with sealed connectors, and where the fault is in a reluctor ring or a wheel bearing encoder, we replace that part rather than just the sensor.

OE or OE-equivalent ABS wheel speed sensors
Reluctor rings where cracked or corroded
Wheel bearings with integral magnetic encoders where required
Sensor wiring and sealed connector repairs

How long it takes

45 minutes–2 hours

A straightforward sensor swap often takes under an hour. Seized sensors, wiring repairs or a reluctor ring or wheel bearing replacement take longer. Most jobs are completed the same day.

What’s included

ABS system fault code scan
Wheel speed live data check
Sensor circuit and reluctor ring inspection
Correct replacement sensor fitted
Fault codes cleared
Road test to confirm the warning lights stay off

Getting here from Streatham

From Streatham to our Hackbridge workshop

From St Leonard's Church take Mitcham Lane (A216) south-west; it becomes Streatham Road and reaches the signalised Figges Marsh junction in Mitcham, where you turn left onto London Road (A217). Follow the A217 around Mitcham town centre's one-way system to the Cricket Green, take Cranmer Road (A239) to Carshalton Road (A237) and head south past Mitcham Junction; past Beddington Corner it becomes London Road into Hackbridge, where Soho Mills is near Hackbridge station.

Take Mitcham Lane and Streatham Road to Figges Marsh, then through Mitcham and down Carshalton Road to Hackbridge, about 20 minutes. Collection is available if you'd prefer.

Directions from Streatham

About Streatham

Streatham is a large, busy south London district strung along the A23, the line of the old London to Brighton road, and is one of London's designated major town centres. It grew from a Georgian spa village into a Victorian and Edwardian suburb, and today mixes big period houses and mansion blocks around Streatham Hill and the Common with terraced streets in Streatham Vale and Streatham Park. It is popular with young families and professionals commuting into central London. Driving here is dominated by the long, slow A23 high road, with residential side streets increasingly shaped by parking zones and traffic filters.

Places nearby: Streatham Common, The Rookery, Norwood Grove, St Leonard's Church, Streatham Ice and Leisure Centre, Streatham Hill Theatre

Postcodes: SW16, SW2 · London Borough of Lambeth (with western fringes in Wandsworth)

More about KITH for Streatham drivers

Questions

ABS Sensor Replacement in Streatham: your questions answered

The ABS light came on after my brakes were done in Streatham. What happened?

Sensors sit right next to the brakes, so they can be knocked or unplugged during the work, and an old corroded sensor may crack when disturbed. We'll check which wheel is affected and whether it's the sensor, the wiring or the connector.

Can I drive from Streatham to Hackbridge with the ABS light on?

Usually, yes, as normal braking still works. Leave extra room, avoid hard braking and take it gently through the busy junctions. If the red brake warning is on too, don't drive it and ask us to collect it.

Do you fix ABS faults on small city cars?

Yes. We diagnose and replace ABS sensors on all makes, from small hatchbacks to SUVs, using OE or OE-equivalent sensors that match your car exactly.

Is it safe to drive with the ABS light on?

The car will still brake normally, so you can usually drive it carefully to the garage. But without ABS and stability control the wheels can lock under hard braking, so leave extra distance. If the brake warning light is on as well, get advice before driving.

Will an ABS light fail the MOT?

Yes. An ABS warning light that stays on, or doesn't come on when the ignition is switched on, is an MOT failure. The same applies to the electronic stability control warning on cars that have it.

Can I just clear the code?

If the fault is still there, the ABS module will find it again, usually within a short drive. Clearing codes without finding the cause just delays the repair.

Why might I need a wheel bearing as well?

On many modern cars the magnetic ring that the sensor reads is built into the wheel bearing seal. If that encoder is damaged or the bearing has excessive play, a new sensor won't cure the fault, and the bearing has to be replaced.

Why did the light come on after my brakes were done?

ABS sensors and their wiring sit close to the brakes and hubs, so they can be knocked, stretched or left unplugged during brake or suspension work. Sometimes an old sensor that was already corroded fails when disturbed. A quick scan shows which wheel is affected.

Instant quote

Price your ABS sensor replacement now

Enter your reg and we’ll look up your car and price the job from our own labour rates and the book time for your model. Then book it in with a fixed written quote before any work starts.

Free, about 30 seconds, no sign-up
Parts, labour and VAT included
3-month workmanship warranty
Collection from Streatham can be arranged

“It’s rare to find a garage you can truly trust. Fair price, brilliant customer service.”Thinushan K. · ★★★★★ Google

Prefer to talk? Call 020 4629 9469 or WhatsApp us.

Loading instant quote…

More for Streatham drivers

Brake Repairs in Streatham · Wheel Bearing Replacement in Streatham · Engine Diagnostics in Streatham · MOT Testing in Streatham · Car Servicing in Streatham · Clutch Replacement in Streatham · Accident Repairs in Streatham · Tyre Fitting in Streatham · Vehicle Recovery in Streatham

ABS Sensor Replacement across South London

ABS Sensor Replacement Tooting · ABS Sensor Replacement Norbury · ABS Sensor Replacement Mitcham · ABS Sensor Replacement Thornton Heath
Beddington · Carshalton · Cheam · Coulsdon · Croydon · Morden · Purley · Rosehill · Sutton · Wallington · Wimbledon · Worcester Park