How we handle battery and electrical repair at Hackbridge
Testing starts with the battery in a known state. A surface charge left by a jump start makes a dying battery read a healthy voltage, so where it matters we charge and settle it first, then test state of health and cold cranking performance with a conductance tester and print the result for you. Cranking voltage is watched while the engine turns over, and alternator output is checked at idle and under load with headlights, heated screen and blower running, because a diode fault or a tired regulator often only shows when the car is asked for real current.
Parasitic drain work is where the time goes, and we are open about that. The car has to be shut up and left until every module has gone to sleep, which on some makes takes the best part of an hour, and only then does a measured draw mean anything. We use a clamp meter or a fused lead in series so the circuit is never broken while the car is awake, then work down from the total draw to the fuse, the circuit and finally the component. Poor earths are found by measuring voltage drop across the joint while it carries current, not by checking continuity, which reads perfectly through a corroded connection.
We do not fit a battery to a car with an untraced drain and call it repaired, because the new one will be flat within the same few days. We do not bridge a fault with a larger fuse or run a permanent live to make something work. Wiring repairs are soldered or crimped properly, sleeved and returned to the loom rather than twisted together under insulating tape. Diagnostic time on an intermittent fault is agreed in blocks before it starts, you hear what we found at the end of each block, and whether to carry on is your call.

