Exhaust Repairs for Purley Drivers, from Silencers to Cats

Speed cushions on roads like Old Lodge Lane are hard on lower cars, and the exhaust is usually the lowest thing underneath. We're about 15 minutes from Purley town centre in Hackbridge, and we check for knock damage as well as corrosion.

  • ★★★★★ 4.9/5 from 193 Google reviews
  • ~15 min from Purley
  • Mon–Fri 8am–8pm · Sat 8am–5pm
Ford van in for engine mount and manifold gasket work at KITH Cars Garage & Bodyworks, Hackbridge

Speed cushions, low exhausts and rattling heat shields

Purley has its share of traffic calming, and Old Lodge Lane is a good example, with speed cushions and a 20mph limit as well as its low railway bridge. Cushions are designed for wide vehicles to straddle, but on a lower car one wheel often rides up the edge while the body dips. The front pipe or a centre silencer can clip the tarmac, and repeated knocks bend pipes out of line and flatten sections.

A flattened or dented section restricts the flow and puts strain on the joints either side, and bent heat shields start to rattle. Many of the newer, premium cars around the Webb Estate and the larger roads nearby have quite low clearance under the centre section, and sports models with bigger exhausts are more exposed still. Those are often the cars that come in with a rattle rather than a blow. Cars used on the steep, winding residential hills around the valley add engine movement, which works the flexi pipe too.

On the ramp we look for scrape marks, crushed pipes, bent brackets and loose heat shields as well as corrosion. Scrape damage often shows at the lowest point of the centre silencer, which we check closely. Heat shields can often be refixed with new clamps rather than replaced, and a pipe that's bent but undamaged can sometimes be realigned, but a crushed or split section needs replacing. We'll explain which is which and give you a written quote before any work starts.

From Purley Cross, the route is up Foxley Lane and Banstead Road to the A237, then straight north through Wallington to Hackbridge, about 4.5 miles. Drivers coming from near Purley War Memorial Hospital on the A23 Brighton Road join the same route at Purley Cross. We can arrange collection and delivery if you'd rather not drive the car, and every repair carries our 3-month workmanship warranty.

Exhaust Repairs: what’s involved

An exhaust does more than carry fumes away. The manifold collects gases from the engine, the catalytic converter cleans them, and on diesels the DPF traps soot. Silencers reduce noise, a flexible section absorbs engine movement, and rubber hangers hold everything clear of the body. Lambda sensors before and after the catalyst tell the ECU how well the engine is burning fuel and whether the catalyst is working.

Exhausts live in a harsh place. Short journeys leave acidic condensation sitting inside silencers, road salt attacks the outside, and speed bumps and kerbs knock pipes out of line. A leak changes more than the noise. It can let fumes into the cabin, upset lambda sensor readings and cause an MOT failure. Catalytic converters are also targeted by thieves, particularly on some hybrids, and a stolen cat needs replacing before the car can be driven legally.

From £205Written quote first
1–3 hoursTypical time in the workshop
3 monthsWorkmanship warranty
4.9★193 Google reviews

Signs your exhaust needs attention

Louder engine or blowing noise

A deeper roar or a chuffing noise that rises with engine speed usually means a hole, a failed joint or a split flexi pipe.

Rattling underneath

Loose heat shields, broken clamps or a collapsed internal baffle in a silencer all rattle, often most noticeably at idle or over bumps.

Exhaust hanging low or knocking

Perished rubber hangers or broken brackets let the system drop and knock against the floor or suspension.

Fumes smell in the cabin

A leak near the front of the system can draw fumes into the car. This needs checking promptly because exhaust gas contains carbon monoxide.

Engine light with catalyst or lambda codes

Catalyst efficiency and lambda sensor codes can mean a failing cat, a faulty sensor or an air leak upstream of the sensor that upsets its readings.

Sudden very loud noise on start-up

An exhaust that sounds dramatically louder overnight, especially on a hybrid, may mean the catalytic converter has been cut out.

Visible rust or holes

Heavy scaling, holes in silencer boxes and corroded joints are usually spotted at service or MOT before they start to blow.

When should it be done?

There is no fixed replacement interval for an exhaust. Life depends on the materials, the car and how it is used, with lots of short trips shortening it most. Get the system checked as soon as the note changes, something is rattling or hanging low, or you smell fumes. A leak or insecure exhaust is an MOT failure, so it makes sense to deal with it before the test rather than after.

  • Any change in exhaust noise, blowing or rattling
  • Fumes smell inside the car
  • Catalyst or lambda sensor fault codes
  • Advisories for corrosion or insecure mountings at MOT or service
  • After suspected catalytic converter theft

How we repair an exhaust

  1. Check-in and listenWe ask what you have noticed and listen to the car running, as the type of noise often points to the area of the leak.
  2. Lift and inspectWith the car on a ramp we inspect the whole system, from the manifold back, including joints, flexi pipe, silencers, hangers, heat shields and sensors.
  3. Check codes where relevantIf there are catalyst or lambda codes we scan the car and check sensor data, so we don't replace a cat when the cause is a sensor or a leak.
  4. Written quoteWe explain which sections need replacing and why, and give you a written quote. Where a section is sound, we keep it.
  5. Remove the old sectionsWe remove the failed parts, cutting seized fixings where necessary, and inspect the joints and brackets we are connecting to.
  6. Fit new partsWe fit the new sections with new gaskets, clamps and hangers, aligning the system so it sits clear of the body and doesn't knock.
  7. Leak test and road testWe run the engine and check every joint for leaks, clear any related codes and road test the car to check for noise and knocks.

Parts we fit

We fit OE or OE-equivalent exhaust parts made to fit the vehicle properly, such as Bosal, Walker or BM Catalysts, rather than universal sections that need bodging to fit. Replacement catalytic converters are type-approved for the vehicle so it meets its emissions standard. We always renew gaskets, clamps and rubber hangers when fitting a new section, as reusing old ones is a common cause of leaks.

  • Vehicle-specific front pipes, centre sections and rear silencers
  • Flexi pipes and manifold gaskets
  • Type-approved catalytic converters
  • Lambda (oxygen) sensors
  • New clamps, gaskets and rubber hangers

How long it takes

1–3 hours

A rear silencer or flexi pipe is often done in an hour or two. Catalytic converters, manifolds and badly seized systems take longer, and some parts may need ordering in.

What’s included

  • Full inspection of the exhaust system on a ramp
  • Written quote before any work starts
  • Removal of failed sections
  • New gaskets, clamps and hangers as required
  • Leak check with the engine running
  • Road test

From Purley to our Hackbridge workshop

From Purley Cross head west up Foxley Lane (A2022) through Woodcote to the mini-roundabout with Woodcote Road and Smitham Bottom Lane (A237). Turn right onto Woodcote Road (A237) and follow the A237 north through Wallington as it becomes Manor Road and then London Road into Hackbridge; Soho Mills is on the right.

Head up Foxley Lane (A2022) from Purley Cross to the A237, then north through Wallington to London Road in Hackbridge, around 15 minutes. If a pipe has been knocked loose and is dragging, we'll collect the car.

Directions from Purley

About Purley

Purley is a green, hilly suburb on the edge of the North Downs about three miles south of Croydon, which grew rapidly in the 1920s and 1930s as a place of spacious homes. Its small town centre sits in a valley around Purley Cross, where the A23, A22, A235 and A2022 all meet, while the surrounding roads climb up to detached and semi-detached houses in Woodcote, Russell Hill, Riddlesdown and the private Webb Estate. It feels quieter and more affluent than central Croydon, but the Purley Cross gyratory is a well-known bottleneck and many side roads are steep and winding.

Places nearby: Purley Cross, Purley station, Purley War Memorial Hospital, Webb Estate, Promenade de Verdun, Russell Hill school buildings

Postcodes: CR8 · London Borough of Croydon

More about KITH for Purley drivers

Exhaust Repairs in Purley: your questions answered

I've scraped my exhaust on a speed cushion. How do I know if it's damaged?

Listen for a new rattle, blow or knock, and look for anything hanging lower than before. Even without symptoms, a hard hit can crack a joint or bend a bracket, so after a heavy knock a quick inspection on the ramp is worthwhile.

Can a heat shield just be refitted instead of replaced?

Often, yes. Rattling heat shields are usually loose where the fixings have corroded, and we can refit them with new clamps. If the shield itself has rotted or split, we'll quote for a replacement.

Do you work on the exhausts of performance models?

We repair and replace standard OE-type systems on most cars, including performance models. For aftermarket or valved sports systems, tell us when you book and we'll check what parts are available before you bring it in.

Do I need a whole new exhaust?

Usually not. Exhausts are made in sections, and we only replace the parts that have failed. If a neighbouring section is badly corroded and likely to break when disturbed, we will tell you and let you decide.

Can you weld my exhaust instead?

Sometimes, where the pipe around a small hole or split is still sound. On thin, corroded silencers a weld often won't last, so a new section is better value. We'll give you an honest view once we see it.

Will an exhaust leak fail the MOT?

Yes. A leaking exhaust, an insecure system or a missing catalytic converter where one was fitted as standard is an MOT failure. Excessive noise and failing the emissions test are also reasons for failure.

My catalytic converter was stolen. What now?

Don't drive the car far. It will be very loud and may run poorly, and it isn't legal on the road without its cat. Report the theft to the police and your insurer, then we can quote for a type-approved replacement.

Do you replace DPFs too?

Yes, where a diesel particulate filter is damaged or too ash-loaded to clean we can quote for replacement. If it is simply blocked with soot, cleaning may be the better option, which we cover under our DPF cleaning service.

Price your exhaust repair now

Enter your reg and we’ll look up your car and price the job from our own labour rates and the book time for your model. Then book it in with a fixed written quote before any work starts.

  • Free, about 30 seconds, no sign-up
  • Parts, labour and VAT included
  • 3-month workmanship warranty
  • Collection from Purley can be arranged
“It’s rare to find a garage you can truly trust. Fair price, brilliant customer service.”Thinushan K. · ★★★★★ Google

Prefer to talk? Call 020 4629 9469 or WhatsApp us.

Loading instant quote…
Chat on WhatsApp